Proceedings of International Conference on Applied Innovation in IT
2023/03/09, Volume 11, Issue 1, pp.297-301

Calculation and Analysis of the Thermal State of the Frequency-Controlled Induction Motor Pump Unit


Ravshan Dusmatov


Abstract: The article presents the results of the application of a method for calculating the thermal state of a frequency-controlled induction motor of closed design in steady-state heating mode. The study analyzes the excess temperature of thermal bodies, particularly the stator winding of the frequency-controlled induction motor installed in the pumping unit. Previous studies on regulated electric drives based on induction motors have focused on low-voltage induction motor drives for general industrial purposes. However, high-voltage induction motors have distinct specific features in terms of design and operation. The study of thermal processes in such motor drives is mainly based on three research methods: the method of heating thermal parameters, the method of the temperature field, and the method of equivalent thermal circuits. The analysis of these methods of thermal calculation showed that the most acceptable method of thermal calculation of regulated high-voltage induction motors is the method of equivalent thermal circuits (ETC). Based on the analysis of the excess temperature of thermal bodies, in particular the stator winding of the frequency-controlled induction motor installed in the pumping unit, it is shown that the optimal frequency control range lies within 30-50 Hz, that is, the frequency reduction causes an increase in temperature in all thermal bodies of the engine.

Keywords: Calculation Method Of Thermal State, Thermal Body, Frequency-Controlled Electric Drive, High-Voltage Induction Motor, Power, Pump, Graph Model.

DOI: 10.25673/101959

Download: PDF

References:

  1. I.Ya. Braslavskiy, Z.Sh. Ishmatov, and V.N. Polyakov, “Energy-saving induction motor drive,” Moscow: ACADEMA, 2004, pp. 280.
  2. М.М. Khamudkhanov, I.A. Abdullabekov, R.K. Dusmatov, N.B. Khamudkhanova, and B.KH. Fayzullayev, “Controls of the modes of operation of the pumping station with application of frequency-controlled electric drive,” in Web of Conferences, II International scientific conference, IOP Conf. Series: Materials Science and Engineering, vol. 862, 2020, pp. 062048IOP. Publishing, [Online]. Available: https://iopscience.iop.org/article/10.1088/ 1757-899X/862/6/062048.
  3. Islombek Abdullabekov and Khushnud Sapaev, “An Energy Efficient Control System for Water Lifting Units of the Ramadan Pumping Station Based on Frequency Controlled Electric Drives,” AIP Conference Proceedings, vol. 2552, no. 1, 2023, article no. 040023, [Online]. Available: https://doi.org/10.1063/5.0130676.
  4. Khushnud Sapaev, Shukhrat Umarov, Islombek Abdullabekov, Nargiza Khamudkhanova, and Maxamanazar Nazarov, “Scheme of effective regulation of pumping station productivity,” AIP Conference Proceedings, vol. 2402, no. 1, 2021, article no. 060016, [Online]. Available: https://doi.org/10. 1063/5.0071557.
  5. Khushnud Sapaev, Islombek Abdullabekov, and Shukhrat Umarov, “Research energy and resource saving operating modes of the pump unit,” E3S Web of Conferences, vol. 216, 2020, article no. 01150, The Authors, published by EDP Sciences, [Online]. Available: https://doi.org/10.1051/e3sconf/20202160 1150.
  6. Khushnud Sapaev, Islombek Abdullabekov, and Shukhrat Umarov, “Critical frequency of autonomous current inverter when operating on active-inductive load,” E3S Web of Conferences, vol. 216, 2020, article no. 01153, The Authors, published by EDP Sciences, [Online]. Available: https://doi.org/10.1051/e3sconf/ 202021601153.
  7. E.B. Saitov and T.B. Sodiqov, “Modeling an Autonomous Photovoltaic System in the Matlab Simulink Software Environment,” AIP Conference Proceedings, vol. 2432, no. 1, 2022, article no. 020022.
  8. E.B. Saitov, Sh. Kodirov, B.M. Kamanov, N. Imomkulov, and I. Kudenov, “Increasing the Efficiency of Autonomous Solar Photovoltaic Installations for Power Supply of Agricultural Consumers,” AIP Conference Proceedings, vol. 2432, no. 1, 2022, article no. 040036.
  9. F. Zikrillayev, E.B. Saitov, J.B. Toshov, B.K. Ilyasov, and M.B. Zubaydullayev, “A Software Package for Determining the Optimal Composition and Parameters of a Combined Autonomous Power Supply System Based on Renewable Energy Sources,” in AIP Conference Proceedings, 2022, vol. 2432, p. 020021.
  10. A.A. Khashimov, A.U. Mirisaev, and L.T. Kan, “Energy-saving induction motor drive,” Tashkent: “Fan va texnologiya,” 2011, p. 132.
  11. A.A. Khashimov, A.E. Serov, and A.T. Imamnazarov, “Electromagnetic and thermal processes in frequency-controlled induction motors. In the book: Automatic machines, electric drives, power semiconductor devices and converter equipment,” Moscow, Energoatomizdat, 1983, pp. 223-231.
  12. A.A. Khashimov, “Electromechanical and thermal processes of frequency-controlled induction motor drive,” Tashkent: Fan, 1997, p. 104.
  13. A.A. Khasimov and R.K. Dusmatov, “The method of drawing up a graph model of the thermal state of an induction motor based on its equivalent thermal circuit,” Bulletin of the Turin Polytechnic University in Tashkent, vol. 4, pp. 79-84, 2018.
  14. A.T. Imamnazarov, “Calculation of heating of induction motors by means of the transformed equivalent thermal circuits,” Journal of Energy and Resource Conservation Problems, Tashkent, vol. 1, pp. 20-25, 2005.
  15. Kh. Sapaev, Sh. Umarov, and I. Abdullabekov, “Critical frequency of autonomous current inverter when operating on active-inductive load,” IOP Conf. Ser.: Mater. Sci. Eng., vol. 216, p. 01153, 2020.
  16. N. Pirmatov and A. Panoev, “Frequency control of asynchronous motors of looms of textile enterprises,” E3S Web of Conferences, vol. 216, p. 01120, 2020.
  17. Kh. Sapaev, Sh. Umarov, and I. Abdullabekov, “Research energy and resource saving operating modes of the pump unit,” IOP Conf. Ser.: Mater. Sci. Eng., vol. 216, p. 01150, 2020.
  18. O. Toirov and S. Khalikov, “Analysis of the safety of pumping units of pumping stations of machine water lifting in the function of reliability indicators,” E3S Web of Conferences, vol. 365, p. 04010, 2023, doi: 10.1051/e3sconf/202336504010.
  19. O. Toirov and S. Khalikov, “Diagnostics of pumping units of pumping station of machine water lifting,” E3S Web of Conferences, vol. 365, p. 04013, 2023, doi: 10.1051/e3sconf/202336504013.
  20. H. Afrisal, A.D. Setiyadi, M.A. Riyadi, R. Ismail, O. Toirov, and I. Setiawan, “Performance Analysis of 4-DOF RPRR Robot Manipulator Actuation Strategy for Pick and Place Application in Healthcare Environment,” International Journal on Advanced Science, Engineering and Information Technology, vol. 12, no. 6, pp. 2258-2265, 2022, doi: 10.18517/ijaseit.12.6.16591.
  21. O. Toirov, D. Jumaeva, U. Mirkhonov, S. Urokov, and S. Ergashev, “Frequency-controlled asynchronous electric drives and their energy parameters,” AIP Conference Proceedings, vol. 2552, article no. 040021, 2023, doi: 10.1063/5.0111331.
  22. N. Pirmatov, O. Toirov, A. Bekishev, N. Kurbanov, O. Zaynieva, and U. Norkulov, “Calculation of U-shaped characteristics and reactive power of synchronous compensator with longitudinal-transverse excitation,” AIP Conference Proceedings, vol. 2552, article no. 040020, 2023, doi: 10.1063/5.0115727.
  23. D. Jumaeva, O. Toirov, Z. Okhunjanov, U. Raximov, and R. Akhrorova, “Investigation of the adsorption of nonpolar adsorbate molecules on the illite surface,” Journal of Chemical Technology and Metallurgy, vol. 58, no. 2, pp. 353-359, 2023.
  24. O. Toirov, S. Urokov, U. Mirkhonov, H. Afrisal, and D. Jumaeva, “Experimental study of the control of operating modes of a plate feeder based on a frequency-controlled electric drive,” E3S Web of Conferences, vol. 288, article no. 01086, 2021, doi: 10.1051/e3sconf/202128801086.
  25. A. Aljwary, Z. Yusupov, O. Toirov, and R. Shokirov, “Mitigation of load side harmonic distortion in standalone photovoltaic based microgrid,” E3S Web of Conferences, vol. 304, article no. 01010, 2021, doi: 10.1051/e3sconf/202130401010.
  26. D. Jumaeva, O. Toirov, N. Rakhmatullaeva, R. Akhmedov, and I. Eshmetov, “Energy of adsorption of polar molecules on NaLSX zeolite,” E3S Web of Conferences, vol. 288, article no. 01041, 2021, doi: 10.1051/e3sconf/202128801041.
  27. D. Jumaeva, A. Abdurakhimov, K. Abdurakhimov, N. Rakhmatullaeva, and O. Toirov, “Energy of adsorption of an adsorbent in solving environmental problems,” E3S Web of Conferences, vol. 288, article no. 01082, 2021, doi: 10.1051/e3sconf/ 202128801082.
  28. A. Shaislamov, N. Abdullaev, and A. Akxrorkhodjaev, “Thermal and Economic Performance of a Solar Hot Water System in Tashkent,” in Networked Control Systems for Connected and Automated Vehicles, 2022, pp. 781-789.


    HOME

       - Call for Papers
       - For authors
       - Important Dates
       - Conference Committee
       - Editorial Board
       - Reviewers
       - Last Proceedings


    PROCEEDINGS

       - Volume 12, Issue 1 (ICAIIT 2024)        - Volume 11, Issue 2 (ICAIIT 2023)
       - Volume 11, Issue 1 (ICAIIT 2023)
       - Volume 10, Issue 1 (ICAIIT 2022)
       - Volume 9, Issue 1 (ICAIIT 2021)
       - Volume 8, Issue 1 (ICAIIT 2020)
       - Volume 7, Issue 1 (ICAIIT 2019)
       - Volume 7, Issue 2 (ICAIIT 2019)
       - Volume 6, Issue 1 (ICAIIT 2018)
       - Volume 5, Issue 1 (ICAIIT 2017)
       - Volume 4, Issue 1 (ICAIIT 2016)
       - Volume 3, Issue 1 (ICAIIT 2015)
       - Volume 2, Issue 1 (ICAIIT 2014)
       - Volume 1, Issue 1 (ICAIIT 2013)


    PAST CONFERENCES

       ICAIIT 2024
         - Photos
         - Reports

       ICAIIT 2023
         - Photos
         - Reports

       ICAIIT 2021
         - Photos
         - Reports

       ICAIIT 2020
         - Photos
         - Reports

       ICAIIT 2019
         - Photos
         - Reports

       ICAIIT 2018
         - Photos
         - Reports

    ETHICS IN PUBLICATIONS

    ACCOMODATION

    CONTACT US

 

DOI: http://dx.doi.org/10.25673/115729


        

         Proceedings of the International Conference on Applied Innovations in IT by Anhalt University of Applied Sciences is licensed under CC BY-SA 4.0


                                                   This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License


           ISSN 2199-8876
           Publisher: Anhalt University of Applied Sciences

        site traffic counter

Creative Commons License
Except where otherwise noted, all works and proceedings on this site is licensed under Creative Commons Attribution-ShareAlike 4.0 International License.